Header image
Footer image
Header image

Contact

Telconi GmbH
Wilhelm-Leibl-Platz 5
81479 Munich
Germany

phone
+49 89 18952960

fax
+49 89 18952959

email
info@telconi.com

home page
www.telconi.com

Telconi Terminal Showcase

Cisco® routers, switches and PIX Firewalls are usually configured using a command line interface (CLI) and require general knowledge of networking technologies, protocols and Cisco IOS® or PIX. Some existing network management applications may cover fault-, software- and other management tasks pretty well. For most other tasks, however, you'll have to step down to the command line interface.

Let's consider a simple task. We're deleting a secondary IP address of an Ethernet interface first using the command line and then using Telconi Terminal:


 

Using the CLI to remove a secondary IP address

First we look at the steps involved using the traditional CLI interface.

router(config-if)# no ip address 10.1.2.3 255.255.255.0 secondary

>> continue

 

Using the Telconi Terminal to remove a secondary IP address

In the second part, we use Telconi Terminal for the same task.


>> continue


 
 

Trademark notice: PIX Firewall is a trademark. Cisco®, Cisco Systems®, Cisco IOS®, and IOS® are registered trademarks of Cisco Systems, Inc. or its affiliates in the U.S. or certain other countries. InterMapper® is a registered trademark of Dartware, LLC. Adobe Reader and Adobe Acrobat are trademarks of Adobe Systems, Inc. Google Earth mapping service is a trademark of Google, Inc. All other trademarks, service marks, registered trademarks, registered service marks mentioned on this page are the property of their respective owners.
 

Panorama header image
Footer image